Type A DSI coupler

Type A DSI coupler

Head only
45.72€ excl. VAT 55.32€ VAT incl.
Skip directly to product information
Type A DSI coupler

Type A DSI coupler

IB0128
45.72€ excl. VAT 55.32€ VAT incl.
VAT depends on destination: mainland Spain and Balearic Islands 21%; Canary Islands are outside EU VAT. Final tax is calculated from the delivery address at checkout.
Shipping calculated at checkout.
Model
Shipping information Request technical advice

Pickup available at Install Beer S.L.

Usually ready in 4 hours

View store information

Type A DSI coupler

Head only

Install Beer S.L.

Pickup available, usually ready in 4 hours

Carrer de Joaquim Valls 109
Local
08042 Barcelona
Barcelona
Spain

+34933464656

DSI keg coupler type A

Dispense coupler for kegs fitted with the specified valve.

Choosing a variant

VariantWhat’s included
Head only
IB0128
Coupler only
Pack with 3/8" John Guest fittings
PK0039
Coupler and John Guest fittings for 3/8″ tubing
DeLuxe pack with 3/8" John Guest
PK0040
Coupler, brass John Guest fittings and protective springs for 3/8″ tubing

Compatibility

DSI identifies this system as Flat type (Flat Top German / Alumasc).

Brand examples: Paulaner, Franziskaner, Hoegaarden. Check the keg valve type before ordering. The brand alone does not establish compatibility.

Installation

With the lever raised, slide the coupler sideways onto the valve as far as it will go, then press the lever down until it locks.

Good practice

The coupler can be dismantled for cleaning and maintenance. Metal hose tails are sold separately.

DSI recommends sanitising the mating face at each keg change and dismantling the coupler for a full clean weekly when the keg is refrigerated. Clean more often if the keg is stored somewhere warm.

Tools and documentation

Frequently asked questions

Which measurements should I check before choosing fittings?

Check the threads of both connections and the tubing outside diameter. The John Guest packs on this page are for 3/8″ tubing.

Technical information

BSP threads on the coupler offered: 1/2″ × 1/2″.

Metal body with stainless-steel components, EPDM seals and check valves for gas and beverage.

Useful accessories and add-ons

Check the correct connections and sizes.

Technical information

Information to choose, install and maintain this product

Keg coupler for kegs fitted with the specified valve.
Compatibility
DSI identifies this system as Flat type (Flat Top German / Alumasc).
Brand examples: Paulaner, Franziskaner, Hoegaarden. Check the keg valve type before ordering. The brand alone does not establish compatibility.
Technical specifications
Thread
Gas inlet 1/2″ BSP and beverage outlet 1/2″ BSP
Connection
Type A keg coupler (flat profile)
Installation and commissioning
With the lever raised, slide the coupler sideways onto the valve until it stops, then lower the lever until it locks.
Maintenance
The coupler can be dismantled for cleaning and maintenance. Metal hose barbs are sold separately.
DSI recommends sanitising the coupling face at every keg change and dismantling the coupler for a thorough clean every week if the keg is refrigerated. Shorten the interval if the keg is stored in a warm place.
The DSI manual specifies cleaning brush 550395 for the body and piston of this system. After brushing, it instructs you to rinse the components with clean water and inspect the seals.
Product FAQs
What should I measure before choosing fittings? Check the thread on both connections and the outside diameter of the tube. The John Guest kits on this page are for 3/8″ tubing.