Portable Pygmy 25/K Exclusive 2-Tap Dispenser

Lindr Pygmy 25/K Exclusive portable dispenser with 2 taps

Approximate delivery time: up to 4 weeks.

The PYGMY 25/K Exclusive NEW is a compact countertop dispenser for two independent beverages, with two taps, an integrated air compressor and a premium backlit front panel. Its THERMOBLOCK contact-cooling system is designed for rapid cooling and stable performance during consecutive serves.

Why choose it

• 2 taps in a very compact format for serving two independent beverages.
• Integrated air compressor for simple portable setups without necessarily relying on CO₂.
• Exclusive design with a customisable backlit front panel.
• Green Line with R290 refrigerant; the manufacturer states approximately 20% higher efficiency and 20% lower consumption than the previous design.
• Two 9 m stainless-steel coils, 18 m total.
• Molecular filter on the compressor air intake.

Technical specifications

Connections and configuration

The beverage inlet uses Speedfit 9.5 mm (3/8") and the compressor air connection uses Speedfit 8 mm (5/16"). The correct keg couplers and the rest of the installation must match the kegs and beverages being served.

Exclusive customisation

• Customisable backlit front-panel graphic.
• White lighting as standard; other colours and designs are available to order according to the manufacturer’s options.
• Tap choice and stainless-steel connection options may vary with the selected configuration.

Recommended for

• Events, tastings, presentations and temporary bars where both design and performance matter.
• Small hospitality venues or as a compact two-line support unit.
• Home users looking for a premium portable two-tap dispenser.

Downloads

Pygmy 25/K Exclusive 2-tap product sheet · Lindr user manual

Serving pace and cooling recovery

Important: these dispensers need time to recover their cooling capacity between batches of pours. They are not intended for leaving the tap open and filling glasses continuously without limit. If the pouring rate exceeds the cooling capacity, the beverage will become progressively less cold and may run warm because the unit has not had time to cool the beverage flowing through the coil. Stop pouring and allow the unit to recover; the pause is usually a few minutes, depending on the model, beverage inlet temperature and ambient temperature. This also applies to higher-capacity models and when using both taps simultaneously.

This dispenser uses dry cooling: the beverage flows through a coil in contact with a refrigerated thermal block, unlike an ice-bank cooler. Pouring several glasses in succession uses the available cooling reserve, and a pause may be needed for the unit to recover its temperature. Serving pace depends on beverage inlet temperature, ambient temperature, serving volume and thermostat setting.

For models 20 and 25, we recommend a measured serving pace. As practical guidance from Install Beer, after pouring two glasses in succession, you may need to wait about two minutes for cooling recovery. This is not a fixed interval or a performance guarantee: adjust it to glass size and operating conditions.

Models with two taps can serve two different beverages simultaneously. Both lines can also be connected to the same keg using a compatible splitter, dedicating both cooling circuits to a single beverage. This uses the unit’s combined capacity to serve that beverage at a higher rate, within the model’s total cooling capacity.